Blade Controllability
There are plenty of ways to control your Blade! You can use it locally (using the buttons), and you can control it via the myAI app and even the Mobius application.
Button Functionality
- When unconfigured, clicking the buttons should cycle through the following settings:
Marine Lights
- All Channels: 1%, 20%, 40%, 60%, 80%, 100%, OFF, then
- Blue/Royal Blue Only: 1%, 20%, 40%, 60%, 80%, 100%, OFF - Return to All Channels
Freshwater Lights:All Channels: 1%, 20%, 40%, 60%, 80%, 100%, OFF
Actinic Lights:All Channels: 1%, 20%, 40%, 60%, 80%, 100%, OFF
Fuge Light:All Channels: 1%, 20%, 40%, 60%, 80%, 100%, OFF
Glocycle (available only on the GloFish Blade):
When the Blade GloFish is not configured, pressing the button cycles through intensities of 1, 20, 40, 60, 80, and 100 percent. Afterward, it enters the “GloCycle” mode. In this mode, Glocycle gradually transitions between each color channel, leaving each channel on for 20 seconds.
When configured, you can enable GloCycle at specific schedule points. This allows the Blade to perform “GloCycle” from the point where it is enabled until the next point. During this period, the Blade will use the chosen intensities of each color channel when cycling the colors.
Actinic Lights:All Channels: 1%, 20%, 40%, 60%, 80%, 100%, OFF
Fuge Light:All Channels: 1%, 20%, 40%, 60%, 80%, 100%, OFF
Glocycle (available only on the GloFish Blade):
When the Blade GloFish is not configured, pressing the button cycles through intensities of 1, 20, 40, 60, 80, and 100 percent. Afterward, it enters the “GloCycle” mode. In this mode, Glocycle gradually transitions between each color channel, leaving each channel on for 20 seconds.
When configured, you can enable GloCycle at specific schedule points. This allows the Blade to perform “GloCycle” from the point where it is enabled until the next point. During this period, the Blade will use the chosen intensities of each color channel when cycling the colors.
When configured:
- Clicking the button once should start a 50% intensity scene for 2hr
- Clicking the button again should start a 100% intensity scene for 2hr
- Clicking the button a third time should resume the schedule
- Pressing and holding the button start a 0% intensity scene for 2hr
Factory Reset:
Factory resetting the device can be accomplished by holding down the button and unplugging the unit from power while holding the button. Power the unit back on while holding the button, then release it when the indicator light starts flashing red.