Support

How do I reconnect the Director to my wireless network?

1) Unplug power to the Director, remove the ethernet connection as well.

2) Plug power back into the Director, make sure the wireless dongle is plugged into the USB port on the Director.

3) Within 30 seconds, the Director will start pulsing red, then go solid red. After which, the Director should start hosting an access point. If the Director does not start hosting an access point, hold the button down on the top of the Director for 3 seconds, until the Director starts to blink green. This will reset the network settings on the Director.

4) Connect to the Director's wireless network, called "director-########", where ######## is the serial number on your Director.

5) In your browser, go to http://director-########.local/, where ######## is the serial number on your Director.

6) Click on the network you want to connect to, and enter in the password, if required. Be sure the password is correct.

7) The Director should turn green within 30 seconds. If the Director goes back to solid red, repeat steps 4 - 6.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Article is closed for comments.