Help Resources/Mounting and Setup Help

About the Hanging Kit

AI Warranty Team
posted this on February 22, 2011 17:21

Here are some simple instructions and pictures of how the hanging kit goes together.

Use the rail end cap screws to attach the short wire in the hanging kit that has the grip lock attached to it to the rails.

IMAG0131.jpg

 

If you have nothing to screw into in your ceiling, use the spring loaded clips and drill a hole in your ceiling to attach the assembly.

IMAG0135.jpg

 

Next, slip the cable through the "Bullet" piece.

IMAG0134.jpg

 

Then push the wire through the griplock connector.

 

IMAG0136.jpg

 

Finally, screw the bullet to the ceiling assembly that has been already secured in the ceiling.

IMAG0133.jpg

 

You can adjust the height of your light system by pulling on the wire coming out of the griplock connector.  To lower it, simply push on the spring loaded part of the griplock while pulling on the wire.